Bacterial Conjugation Experiment Essay, Research Paper
INTRODUCTION: Bacteria, in general, reproduce asexually, but in order to increase diversity, they have developed a mechanism for transfer of genetic material from one bacterium to another. The ability to perform this transfer is conferred by a set of genes which are called F for ‘fertility.’ These genes exist on a small, circular piece of deoxyribonucleic acid (DNA) that replicates independently from the bacterial chromosome, or they can be integrated into the chromosome. The bacterium containing this gene (sometimes referred to as ‘male’ or F+) extends its pilus to a neighboring bacterium (sometimes referred to as ‘female’ or F-), and the two cells are attached. This process is called conjugation. The third manifestation of the F factor is Hfr, which is the term for the F element becoming integrated into the genome. When conjugation occurs, the F genes start travelling across the pilus, bringing the remainder of the genome behind it. Most often, the entire genome isn’t transferred. The bacterial genome that is delivered can be measured in minutes from the origin of transfer. That is, the amount of time it takes for a particular gene to be transferred from one bacterium to another indicated how far it is from the origin of replication.
METHODS AND MATERIALS: Media Preparation: The starting material was Medium 56-glucose agar (MM560). The components of the MM56 are found in figure 1. From this, we made two types of media, complete and selective. The reagents used, along with their stock and final concentrations are found in figure 2. The formula:
Stock volume = [(Final concentration)(final volume)] / (stock concentration)
was used to calculate the amounts of each reagent added to the complete and selective media. (The final volume was 600 ml.) These values are also found in figure 2. To make the complete media, appropriate amounts of each amino acid, glucose, vitamin B1, and streptomycin were aseptically added to the MM56 media and poured into sterile petri plates. The selective media was prepared so that 84 plates were made. These plates were made much in the same way as the complete plates, except that 28 of the plates contained all of the reagents except proline, another 28 were without histadine, and another 28 were without threonine. These were labeled with “pro-”, “his-”, and “thr-”.
Viable Counts: The strain used was Escherichia coli K12. The donor and recipient cultures were kept as much as possible in a water bath at 37?C. Viable counts of the donor (Hfr) and recipient were done on complete MM56 and Luria agar. Serial dilutions were performed to obtain a 10-7 and 10-8 dilutions of the recipient, and 10-2, 10-7, and 10-8 dilutions of the donor. Two Luria plates were inoculated with 1 ml each of the 10-7 dilution of the recipient. Two Luria plates were inoculated with 1 ml each of the 10-8 dilution of the recipient. Two Luria plates were inoculated with 1 ml each of the 10-7 dilution of the donor. Two Luria plates were inoculated with 1 ml each of the 10-8 dilution of the donor. Two complete MM56 plates were inoculated with 1 ml each of the 10-7 dilution of the recipient. Two complete MM56 plates were inoculated with 1 ml each of the 10-8 dilution of the recipient. One complete MM56 plate was inoculated with 1 ml of the 10-2 dilution of the donor. Each of these were inoculated for 48 hours.
Conjugation: 30 sterile test tubes were filled with 9 ml each of sterile saline solution. A supply of sterile top agar was kept in a water bath to keep liquid until needed. One ml of the donor culture was added to 20 ml of the recipient culture in a flask. This mating mix was kept in the 37?C water bath. Immediately (0 minutes), 1 ml of the mating mix was removed from the flask and added to 9 ml of sterile saline, making a 10-1 dilution. This was placed on the vortex for 60 seconds to interrupt any mating taking place in the mix. 1 ml of this mixture was added to another tube of 9 ml sterile saline, making a 10-2 dilution and this solution was vortexed for one minute. This was repeated twice more to produce a 10-3 and a 10-4 dilution. For each dilution, three tubes of top agar were inoculated with 1 ml of that dilution. One each of the agar-dilution mixtures were poured onto a threonine deficient plate, a proline deficient plate, and a histadine deficient plate. This procedure was repeated every ten minutes for sixty minutes. The top agar was allowed to harden and the plates were incubated at 37?C for 48 hours.
RESULTS: After incubation, the plates were removed and colony counts were performed (figure 3). The time of entry of each gene was calculated, using this formula:
[(Recipient/ml)/(donor/ml)] * 100.
The calculated times of entry are found in figures 4 and 5. From this information, a map of E.coli K12 was constructed (figure 6).
DISCUSSION: The time of entry of the amino acid threonine was found to be consistent with that found in the lecture handout “Bacterial Gene Transfer – Conjugation”. The time of entry for proline (10 minutes) was longer that the handout value of about 5 minutes. The actual time for proline might have been 5 minutes, but the samples were taken at 10 minute intervals. The time of entry for histadine (10 minutes) differed drastically than the handout time of about 44 minutes. These discrepancies could be caused by a variety of errors. The cultures could have been contaminated. The media could have been prepared incorrectly. The wrong amino acids could have been added or the plates could have been labeled incorrectly. The amount of time spent vortexing the mixes (in order to separate the mating pairs) might have been insufficient. Also, the dilutions were placed on the vortex before making each dilution, instead of only after taking the sample directly from the flask in the water bath.
Figure 1 – MM56 Components
Chemical Amount in 1L of MM56
Na2HPO4 (0.1M) 611 ml
KH2PO4 (0.1M) 384 ml
MgSO4o7H2O (10%) 2 ml
(NH4)2SO4 (10%) 1 ml
Cu(NO3)2 (15%) 1 ml
FeSO4o7H2O (0.05%) 1 ml
Figure 2 – Reagents used
Reagent Stock concentration Final concentration Calculated
stock volume
Streptomycin 50 mg/ml 200:g/ml 2.4 ml
DL- Threonine 1% in H2O 10 ml/L 6 ml
L-Leucine 2% in H2O 10 ml/L 3 ml
L-Proline 2% in H2O 10 ml/L 3 ml
L-Histadine 1% in H2O 5 ml/L 3 ml
L-Arginine 6% in H2O 33 ml/L .33 ml
Vitamin B1 0.1% in H2O 0.2 ml/L 1.2 ml
Glucose 40% 10 ml/l 1.5 ml
Figure 3 – Colony counts
Threonine deficient plates
Time 10-1 10-2 10-3 10-4
0 minutes TNTC TNTC 96 17
10 minutes 41 TNTC TNTC 127
20 minutes 38 5 TNTC 148
30 minutes 88 4 TNTC TNTC
40 minutes 216 TNTC TNTC TNTC
50 minutes 34 5 TNTC 42
60 minutes NG 6 TNTC 53
Proline deficient plates
Time 10-1 10-2 10-3 10-4
0 minutes NG NG NG 3
10 minutes 37 NG TNTC 44
20 minutes 49 TNTC TNTC 58
30 minutes 43 TNTC TNTC 40
40 minutes 11 5 TNTC 94
50 minutes 53 TNTC 50 51
60 minutes 14 NG TNTC NG
Histadine deficient plates
Time 10-1 10-2 10-3 10-4
0 minutes 10 2 NG NG
10 minutes 46 43 26 3
20 minutes TNTC 136 NG 4
30 minutes TNTC 184 8 3
40 minutes TNTC 340 20 NG
50 minutes 45 TNTC 27 3
60 minutes 41 250 42 NG
TNTC = Too numerous to count
NG = No growth
Figure 4 – Time of entry table (percentages of recombinants)
Time Thr – Pro – His -
0 minutes .44 0 0
10 minutes 5.8 2 .02
20 minutes 6.7 2.6 .06
30 minutes .004 1.8 .08
40 minutes .0098 4.3 .09
50 minutes 1.9 2.3 .002
60 minutes 2.4 0 .11
Figure 5 – Time of entry graph (percentages of recombinants)
Figure 6 – Map of E. coli K12